Author name: Phil Budzynski

Floor Scrubber Battery Charging Floor Scrubbers should be plugged in at all times when not in use. Floor Scrubbers that are not plugged in can self- discharge over time and kill your battery pack. Batteries should be charged after each use – no matter how short of a time. When plugging the charger into the

How to Maintain Floor Scrubber Batteries Maintain water levels in each cell of each battery to ¼ of an inch above the cell battery plates with distilled water. Do not allow the plates to be exposed to air. Charge your floor scrubber batteries often and after every use. If your floor scrubber sits for more

My Floor Scrubber Charger Will Not Turn On and Charge The most frequent question we get concerning problems automatic floor scrubbers is a suspected bad battery charger. If you haven’t used your floor scrubber in a long time, the batteries are dead and the charger doesn’t charge the batteries – most of the time it

Blem Batteries Blem batteries or Blemish batteries are sold by battery manufacturers to mostly all of their large dealers and carry the same warranty as New (non-blemish battery) at a lower cost. It is easy to identify blem batteries on your floor scrubber, check the top of the battery and the letter B or the

My Floor Scrubber will Not Move: Make sure the batteries are charged Make sure the outlet you used to plug the charger in works properly If you charged your machine the previous day and the charger is still charging then you probably have a bad battery. Load test your batteries if possible. Make sure battery

My Floor Scrubber is Not Cleaning the Floor: Inspect that your floor pads are installed on the machine, that they are the correct size and not worn. Are the correct type of pads for the surface you are cleaning installed. Make sure you adjust pad pressure correctly and that you do not have too much

My Automatic Floor Scrubber is Not Picking Up Water: Make sure vac motor is running, if not you could have a bad vac motor Make sure hose is attached to squeegee assembly and tight Make sure hose is attached to recovery tank and tight Make sure vac hose does not have any holes, slices, cracks

There is no water or little water coming out of my floor scrubber: Make sure key is in the ON position Make sure unit is charged Make sure wires on batteries are connected Make sure switches on dash are turned on and getting power Make sure there is water in the tank. Clean the water